To Create a Plug or Slot Weld

Slot or Plug Weld · Width or diameter of slot should not be less than three times the thickness of the part in which slot is formed or 25 mm,

To Create a Plug or Slot Weld So it's a slot & tab assembly ? the weld cap instruction over top of the symbol No sin in adding words in a note next to the weld, main point

Slot or Plug Weld · Width or diameter of slot should not be less than three times the thickness of the part in which slot is formed or 25 mm,

plug or slot weld PLUG AND SLOT WELDS These weld types are used for joining metals which are overlapping on each other Plug weld: This weld can be defined as a

Students also viewed Plug welds and slot welds are identified by the same symbol, except that the plug weld symbol has a diameter symbol placed on its right

plug weld and slot weld For example, if a diameter of a hole for a plug weld is to be 6mm, the plug weld symbol will be accompanied by Ø6 on its right side, signifying

Slot weld is also shown in the figure above It is quite similar to the plug weld, except that the hole is not circular, it is an elongated hole